Give your BB86/92 frame a quiet, corrosion-resistant bottom bracket for Shimano 24mm cranksets. Enduro's TorqTite cups thread together through the press-fit shell and hold 440C stainless steel angular contact bearings in parallel alignment for creak-free, low-friction pedalling.

Highlights

• TorqTite thread-together cups for BB86/92 press-fit frames
• Fits Shimano 24mm cranksets
• 440C stainless steel balls and races for long life and corrosion resistance
• LLB dual-lip groove seals with high-pressure grease
• Black finish

How TorqTite works

TorqTite is an original Enduro design for non-threaded, press-fit shells. The precisely machined aluminium cups thread together through the shell for a simple, secure installation, and Enduro machines them to keep the two bearings parallel, which is what keeps the bottom bracket quiet, creak-free and low in friction.

Stainless bearings & seals

This is a complete bottom bracket built around 440C stainless steel balls and races in an angular contact layout. Enduro is upfront that stainless steel carries about 20% less load than its standard 52100 chromium steel and is slightly softer, but it chooses stainless where corrosion is the bigger enemy: wet rides, road salt, sweat, spilled sports drinks and frequent washing. LLB dual-lip groove seals and high-pressure grease add another layer of protection against water and grime.

Fitting & servicing

Enduro says the tool splines on these cups are a standard Shimano FC32 type, and recommends its BBT-44x16 cup tool and/or BBT-010 TorqTite flat wrench for installation.

Our workshop can fit it for you as a separate service. Enduro also asks for its stainless bottom bracket bearings to be cleaned and re-greased by a qualified mechanic every six months to keep the warranty valid, and we can look after that too.

Compatibility & fit

• Frame: BB86/92 press-fit bottom bracket shell
• Crankset: Shimano 24mm cranksets
• Check your frame's shell standard and your crank's spindle before ordering, or ask our workshop to confirm the fit.