Bring a crashed or worn Hope lever back to factory spec. This is the complete EVO master cylinder – the lever and master cylinder assembly from Hope's EVO brake range, machined and assembled in Barnoldswick, UK.

Highlights

• Complete EVO master cylinder and lever assembly
• EVO cam reduces free lever stroke while keeping Hope's trademark modulation
• Bleed port in the master cylinder body – bleed without removing the lid
• Reach and bite point adjustment
• Left or right hand; Silver/Black or Black/Black

Firmer bite, same smooth feel

Hope's EVO cam shortens the dead travel before the pads bite, giving a slightly firmer feel at the bite point followed by a gentle rise in power. The roller-bearing main pivot and sliding guide bush carry over from Tech 4, with an extra guide bush keeping the piston running straight through the whole stroke.

Easier bleeding

A bleed port in the body lets you bleed without taking the lid off, and the internal ports were reworked to stop air pockets forming. The classic open bleed is still there for a full service. The standard lever blade suits most riders; Hope's Power and Control blades are sold separately.

Options

Compatibility & fit

For Hope EVO brake systems. On Australian-set-up bikes the right-hand lever normally runs the front brake and the left-hand lever the rear – check the side you need against your current setup. Hose, caliper and fluid are not included; a bleed is required after fitting. Installation is a separate Tune Cycles workshop service – book a workshop service.