A 12mm thru-axle built for the NAILD thru-axle system, so bikes with a 12x142 NAILD rear end can tow a BOB Trailer instead of using the BOB Trailer's original quick-release mount.

Highlights

  • M12x1.0 thread pitch
  • Built for 12x142 NAILD thru-axle hubs
  • 7075 aluminium shaft, hard black anodised; stainless steel axle ends
  • Installs and removes with a standard 5mm hex key, no special tools

Fit

NAILD thru-axles are used on specific bikes (Robert Axle Project names Marin and Polygon models among them); thread pitch and hub width both have to match your bike exactly. Check your bike against Robert Axle Project's online Axle Finder before ordering.

Compatibility & fit

Fits bikes with a 12x142 NAILD thru-axle rear end and M12x1.0 dropout thread. The Tune workshop can measure your existing axle and fit the new one.

Robert Axle Project backs this product with its Lifetime Warranty: free from defects in materials and workmanship, to the original purchaser, for as long as you own it. Normal wear and tear, misuse, neglect, improper installation or maintenance, alteration and accident damage aren't covered. For warranty support, return the product to Tune Cycles and we'll manage the claim with Robert Axle Project's Australian distributor. This is in addition to your rights under the Australian Consumer Law, so keep your proof of purchase.
  • M12x1.0 thread, for 12x142 NAILD hubs
  • 7075 aluminium, hard black anodised, stainless steel ends
  • 5mm hex key install, no special tools
BrandRobert Axle Project
TypeBOB Trailer thru-axle, NAILD system
Thread pitchM12x1.0
Hub fit12x142 NAILD
Diameter12mm
Material7075 aluminium shaft, stainless steel ends
Tool5mm hex key
SKU DTW-RAG-BOB117.N
Barcode # 602150472951
Brand Robert Axle Project