Refresh your shifting with a complete, premium gear cable and housing kit from SRAM. The SlickWire Pro pairs low-friction stainless cables with compression-free housing for crisp, reliable shifts across the whole cassette, in a clean black finish to match your build.

Highlights

• Complete front and rear shift cable refresh in one kit
• 1.1mm polished stainless steel inner cables for smooth, precise actuation
• 4mm compression-free nylon-braid housing with a lubricated liner
• Includes everything to do the job: cables, housing, ferrules, end caps and frame protectors
• Works on both road and mountain bikes
• Black finish

Smooth, accurate shifting

The polished 1.1mm stainless steel inner wires slide with minimal friction, so lever input translates straight into clean, repeatable gear changes. The 4mm nylon-braid outer housing is compression-free with a lubricated liner, holding its length under load so indexing stays consistent and shifts stay sharp over time.

A full kit, ready to fit

This is a complete two-cable kit supplied with 2 x 2300mm inner cables, enough 4mm housing for a typical front and rear routing, plus short-nosed aluminium ferrules, end caps and frame protectors. The generous 2300mm cable length suits everything from compact road frames to long-routed mountain bikes.

Compatibility

Designed for mechanical (cable-actuated) drivetrains and compatible with both road and MTB setups. The SlickWire Pro is intended for mechanical shift systems; it is not used with fully wireless electronic groupsets. If you are unsure whether your shifters and derailleurs use this cable type, contact our team before ordering.